Semestre 4 - Module 3

Discutez de ces questions sur le forum Cisco
Back au sommaire

1 How did Cisco alter the HDLC encapsulation to allow a single link to carry multiple protocols?

split the transmissions into multiple channels each carrying a single protocol

identified the protocol in the FCS field

compressed the datagrams differently for each protocol

added a type field to identify the protocol

2 A technician has used Telnet to gain remote access to a router that has no connectivity on its serial interface. Which command should be issued to determine if the serial cable is connected properly?

show controllers

show processes

show run

show status

3 A two router network is running PPP over the serial interfaces that connect them. The enable password on the Denim router is "gateway". The Denim router also has a locally configured authentication password for the Plaid router which is "fortress". Which command must be executed on the Plaid router to allow Denim to authenticate to the Plaid router using CHAP?

Plaid(config)# enable secret gateway

Plaid(config)# enable secret fortress

Plaid(config)# username Plaid password fortress

Plaid(config)# username Denim password fortress

Plaid(config)# hostname Plaid secret password gateway

Plaid(config)# hostname Plaid secret password fortress

4 Which authentication protocol can be spoofed to allow playback attacks?





5 How is the MD5 function valuable in authentication? (Choose two.)

uses a one-way hash function

authentication occurs more rapidly

challenges are unique

the remote router assumes control of frequency of challenge

the remote router assumes control of timing of challenge

6 Which command specifies a link quality over a PPP link?

ppp link 50

ppp link quality 60

ppp percentage 80

ppp quality 90

7 Refer to the output of the show interface Serial0/0 command in the graphic. How many NCPs have been established?






8 Which of the following is an advantage of using time-division multiplexing (TDM) for transmitting data? (Choose two.)

It allows a single source to transmit over multiple data channels.

Multiple sources can transmit over a single channel.

Original data streams must be reconstructed at the destination.

TDM relies on Layer 3 protocols to operate.

9 Which of the following describes the High-Level Data Link Control protocol? (Choose three.)

HDLC provides flow and error control.

Standard HDLC supports multiple protocols on a single link.

HDLC uses sequencing and acknowledgements.

HDLC is defined as the default encapsulation on Cisco LAN interfaces.

Cisco implemented a proprietary version of HDLC.

10 A technician is testing the functionality of a recently installed router. The technician is unable to ping the serial interface of a remote router. The technician executes the show interface serial 0/0 command on the local router and receives the following output:

Serial0/0 is up, line protocol is down(disabled)

What are possible causes for this command output? (Choose two.)

interface missing the no shutdown command

clockrate command missing

CSU/DSU failed

interface shutdown due to high error rate

cable missing

11 When troubleshooting the Serial 0/0 interface of a router, a technician issues the show controllers command. The following was the output of the command:

Interface is Serial0/0, electrical interface is UNKNOWN.

What can be concluded about the Serial 0/0 interface? (Choose three.)

Serial0/0 is down, line protocol is down

Serial0/0 is down, line protocol is up

Serial0/0 is up, line protocol is down

The interface is neither DCE or DTE.

The interface hardware may be faulty.

The cabling may be improperly connected.

12 ISDN BRI service uses two B channels to send data, voice, and video. If the first channel becomes saturated, the second channel can be configured to forward packets. Which command will allow ISDN to load balance across both links?

Router(config-if)# ppp quality 2

Router(config-if)# ip variance

Router(config-if)# ip maximum-paths 2

Router(config-if)# ppp multilink

13 Which of the following describe functions of the Point-to-Point protocol with regards to the OSI model? (Choose three.)

PPP uses Layer 3 of the OSI model to establish and maintain a session between devices.

PPP operates at all layers of the OSI model.

PPP uses the data link layer to configure such options as error detection and compression.

PPP provides a mechanism to multiplex several network layer protocols.

PPP uses Network Control Protocols (NCP) to test and maintain connectivity between devices.

PPP can be configured on both synchronous and asynchronous serial interfaces.

14 PPP uses several protocols for communication. Which of the following are options that the LCP protocol in the PPP architecture can provide? (Choose two.)

testing the quality of the link

routing packets between devices

assigning individual station addresses

configuring network layer protocols

negotiating authentication options

15 Several tasks must occur before a link between two routers can pass data using PPP. Which of the following are required to establish and maintain a PPP session between two routers?

configure each host with a PPP address

configure authentication between the two routers

send LCP and NCP frames to negotiate configuration parameters

send hostname and password information between the two routers

16 Which of the following is a reason for using such protocols as PAP and CHAP?

to establish a PPP session

to provide error checking on a WAN link

to restrict access to networks connected by serial and ISDN links

to provide a backup hostname and privilege mode password on the router

17 Which of the following describes the CHAP protocol? (Choose three.)

exchanges a random challenge number during the session to verfiy identity

sends authentication password to verify identity

prevents transmission of login information in plain text

disconnects the PPP session if authentication fails

initiates a two-way handshake

18 Which command was used to display the partial output shown in the graphic?


show ppp traffic

show lcp traffic

debug ppp negotiation

debug ppp authentication

19 What can be concluded from the output shown in the graphic? (Choose three.)


A two-way handshake is occuring.

The LCPs were already negotiated.

The router can begin NCP negotiations.

The debug ppp negotiation command was executed.

The debug ppp authentication command was executed.

20 Which advantage does the multilink option provide when using PPP?

Data transmission has load balancing possibilities.

Interfaces can be configured using both HDLC and PPP.

More than one authentication method can be used.

More than one compression protocol can be configured.

Discutez de ces questions sur le forum Cisco
Back au sommaire

mot clé : reponse question ipv6 entrainement vpn voip Examen module semestre tcpip ip questions ipv4 cisco blanc réponses ccna

Copyright © 2011-2015 FrameIP TcpIP. Tous droits réservés. Les marques et marques commerciales mentionnées appartiennent à leurs propriétaires respectifs. L'utilisation de ce site Web TcpIP implique l'acceptation des conditions d'utilisation et du règlement sur le respect de la vie privée.
Sécurité entreprise Téléphonie entreprise Expert de votre Infrastructure Test ADSL Serinya Operateur Telecom